This part was misleading because I saw on my National Instruments system but not the DAMA DAMA and RFSG vi. For some reason, the equipment was delivered to me with DAMA and RFSG, but only for C. I had to install the RFSG and ACD for labVIEW. If I do, how I run on my controller? What are my other options? When I checked online it says I have to buy the cd/dvd of MT. Also, I opened MAX and under "Software", I could find DAA, pilots RFSG etc but not the Mt. I checked for the TM in the start menu-> all programs-> national instruments-> modulation but in vain. I opened a code that uses this DAMA close.vi and since I donot have probably MT, I can't run since the claim code to choose the path! Now I cannot access some screws RF Toolkit as NI DAMA close.vi etc. He came with DAMA RFSG but not the Modulation Toolkit (TM). I have an on-board controller: 8106 PXI OR PXI 56.
Modulation toolkit for labview for embedded controller PXI-8106
Let me know if this clears up things or if you have additional questions. You set this value of divisor of the project for the e/s specific PWM. Thus, with a 50 MHz clock and a 16 - bit divider, you would get 50 MHz/2 ^ 16 = 762, and therefore the lowest frequency you can achieve (using the value of the divisor of 64) would be around 12 Hz. For example, if you set the output frequency 4, you also set the output frequency 5 because the two outputs share a common time base. This property affects the dating: 0/1, 2/3, 4/5. To change the predivider, click the basic I/o node in the Project Explorer window, and then select Properties. If you need a lower frequency, predivide based on the system clock of time PWM. For example, if the system clock is 50 MHz, the lowest possible PWM frequency is about 760 Hz. «The PWM frequency is the inverse of the period PWM.» A 16-bit system clock divider controls the frequency. Set you the divider in the properties of elementary school of e/s of the project? Here is some information pulled using LabVIEW: Just to add some information about PWM with LabVIEW Embedded for ARM. Thanks for posting on the Forum of National Instruments. I'm trying to generate PWM with Laminary LM3S8962 signals.Īt first, I thought that always the entrance of the PWM output is the ratio between the width of the pulses.īy changing the value "PWM Input" AI0 strangely varies LabView PID control with PWM output and ramp / soak.
0 kommentar(er)
